Craftsman 917.272680 - Manual (Page 22)

• Clean engine, battery, seat, finish, etc.
of ail foreign matter.
• Keep finished surfaces and wheels free
of all gasoline, oil, etc.
• Protect painted surfaces with auto­
motive type wax.
We do not recommend using a garden
hose or pressure washer to clean your
tractor unless the engine and transmis­
sion are covered to keep water out. Water
in engine or transmission will shorten the
useful life of your tractor. Use compressed
air or a leaf blower to remove grass,
leaves and trash from tractor and mower.
SERVICE AND ADJUSTMENTS
A
WARNING: TO AVOID SERIOUS INJURY, BEFORE PERFORMING ANY
SERVICE OR ADJUSTMENTS:
1. Depress clutch/brake pedal fully and set parking brake.
2. Place motion control lever in neutral (N) position.
3. Place attachment clutch in “DISENGAGED” position.
4. Turn ignition key to “STOP” and remove key.
5. Make sure the blades and all moving parts have completely stopped.
6. Disconnect spark plug wire from spark plug and place wire where it cannot
come in contact with plug.
TRACTOR
TO REMOVE MOWER
Mower will be easier to remove from the
right side of tractor.
1. Place attachment clutch in “DISEN­
GAGED” position.
2. Move attachment lift lever forward to
lower mower to its lowest position.
3. Roll belt off engine pulley.
4. Remove small retainer spring, and
remove dutch spring off pulley bolt.
5. Remove large retainer spring, slide
collar off and push housing guide out of
bracket.
6
.
Disconnect anti-sway bar from chassis
bracket by removing retainer spring.
Disconnect suspension arms from rear
deck brackets by removing retainer
springs.
Disconnect front links from deck by
removing retainer springs.
Raise lift lever to raise suspension
arms. Slide mower out from under trac­
tor.
IMPORTANT: If an attachment other than
the mower deck is to be mounted on the
tractor, remove the front links and hook
the clutch spring Into square hole in frame.
7.
8
.
9.
Small Retainer Spring
Clutch Spring
Flat Washer.
Small Retainer Spring
Clutch Spring
Retainer Spring
Anti-Sway Bar
Housing
Guide
Large
Retainer
Spring
Square Hole
Engine Pulley
Retainer Springs
(Both Sides)
Deflector
Shield