Craftsman 315.228110 User Manual
Owner's manual 10 in. table saw, Model no, Caution
Advertising
Table of contents
Document Outline
- Owner's Manual
- 10 in.
- TABLE SAW
- MEANING
- SAFETY ALERT SYMBOL
- IMPORTANT
- READ ALL INSTRUCTIONS
- SAVE THESE INSTRUCTIONS
- ELECTRICAL
- EXTENSION CORDS
- ELECTRICAL CONNECTION
- SPEED AND WIRING
- GROUNDING INSTRUCTIONS
- OPERATING COMPONENTS
- SPEED AND WIRING
- SAFETY DEVICES
- POWER SWITCH
- TO TURN YOUR SAW ON:
- TO TURN YOUR SAW OFF:
- TO LOCK YOUR SAW SWITCH:
- BLADES
- ASSEMBLING LEG STAND
- ASSEMBLING STORAGE BRACKETS
- MOUNTING THE LEG STAND ON THE TABLE
- SAW BASE
- B. ASSEMBLY OF RAILS, TABLES, AND FENCES
- TO INSTALL FRONT AND BACK RAILS
- TO INSTALL MITER TABLE AND FENCE
- TO INSTALL ACCESSORY TABLE AND RIP
- FENCE
- C. BLADE CHECK AND BLADE GUARD ASSEMBLY
- TO CHECK SAW BLADE INSTALLATION
- TO INSTALL BLADE GUARD
- A. GENERAL INFORMATION GROUNDING
- TYPES OF CUTS
- CUTTING TIPS
- TO CHECK, REPLACE OR ADJUST THE RIVING KNIFE AND BLADE GUARD ASSEMBLY
- TO REDUCE RISK OF KICKBACK
- TO MAKE A PUSH STICK
- FEATHERBOARD
- HOW TO MAKE A FEATHERBOARD
- HOW TO MOUNT A FEATHERBOARD
- TO ADJUST THE BLADE DEPTH
- TO ADJUST THE BLADE ANGLE
- TO SET THE SCALE TO THE BLADE
- TO LOCK MITER TABLE
- C. MAKING CUTS
- TO MAKE A STRAIGHT CROSS CUT
- TO MAKE A MITER CUT
- TO MAKE A STRAIGHT RIP CUT
- TO MAKE A BEVEL CROSS CUT
- TO MAKE A BEVEL RIP CUT
- TO MAKE A COMPOUND MITER CUT
- TO MAKE A LARGE PANEL CUT
- TO MAKE DADO CUTS
- A. GENERAL MAINTENANCE
- B. SPECIFIC TABLE SAW MAINTENANCE
- TO SET BLADE AT 0 OR 45 DEGREES
- TO CHECK THE ALIGNMENT OF THE RIP
- FENCE TO THE BLADE
- TO ADJUST THE BEVEL LOCKING LEVER
- TO ALIGN THE MITER LOCKING CLAMPS
- TO ADJUST THE FRONT AND REAR RAIL CLAMPS
- TO ADJUST THE ACCESSORY TABLE
- CHECKING SLIDING MITER TABLE ASSEMBLY
- TO CHECK MITER BASE PARALLELISM
- TO CHECK MITER FENCE ALIGNMENT
- TO ADJUST THE MITER FENCE
- TO ADJUST QUICK-STOP
- LOCKER BRACKET ASSEMBLY
- TILT / ELEVATING MECHANISM
- ELECTRICAL