Craftsman 358.795543 User Manual
Page 5
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
For proper orientation of shield, see
KNOW YOUR TRIMMER illustration in OP
ERATION section.
1. Remove wing nut from shield.
2. insert bracket into slot as shown.
3. Pivot shield until bolt passes
through hole in bracket.
4. Securely tighten wing nut onto bolt.
OPERATION
KNOW YOUR TRIMMER
READ THIS INSTRUCTION MANUAL AND SAFETY RULES BEFORE OPERATING YOUR
UNIT. Compare the illustrations with your unit to familiarize yourself with the location
of the various controls and adjustments. Save this manual for future reference.
Tube
Trimmer
Head
Edge
Guide
ON/OFF SWITCH
The ON/OFF switch is used to stop en
gine. To stop the engine, move switch
to the OFF position.
PRIMER BULB
The PRIMER BULB removes air from
the carburetor and fuel lines and fills
them with fuel. This allows you to start
the engine with fewer pulls on the
starter rope. Activate the primer bulb
by pressing it and allowing it to return
to its original form.
CHOKE
The CHOKE helps to supply fuel to the
engine to aid in cold starting. Activate
the choke by moving the choke lever to
the FULL CHOKE position. After the en
gine attempts to start, move the choke
lever to the HALF CHOKE position. Once
engine has started, move the choke le
ver to the OFF CHOKE position.
EDGE GUIDE
The EDGE GUIDE protects the unit
from contacting the ground during
edging.
BEFORE STARTING ENGINE
^WARNING:
Be sure to read
the fuel information in the safety rules
before you begin. If you do not
understand the safety rules, do not
attempt to fuel your unit. Call
1-800-235-5878.
FUELING ENGINE
WARNING:
Remove fuel cap
slowly when refueling.
This engine is certified to operate on
unleaded gasoline. Before operation,
gasoline must be mixed with a good
quality synthetic 2-cycle air-cooled