Brush replacement, Accessories, Maintenance – Craftsman 315.279840 User Manual

Page 13

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Advertising
background image

MAINTENANCE

BRUSH REPLACEMENT

See Figure 10.

■ Unplug the sender.

■ Remove screws (3) from top cover of sender.

■ Remove top cover.

■ Remove clamp screws (2}.

■ Remove brush tube clamps (2).

■ Disconnect red and black lead terminals from brush

tubes.

■ Remove brush assemblies (2).

■ Check for wear. Replace both brush assemblies when

either has less than 1M in. length of carbon remaining.
Do not replace one side without replacing the other.

■ Install new brush assemblies. Make sure curvature

of brush matches curvature of motor and that brush
moves freely in brush tube.

■ Reassemble by reversing the steps listed above.

■ Tighten ail screws securely. Do not overtighten.

SCREWS

TOP

COVER

CLAMP

SCREWS

BRUSH

TUBE

CLAMPS

№D LEAD

BRUSH

ASSEMBLY

BLACK

LEAD

Fig. Ì0

ACCESSORIES

The following recommended accessories are currently available at Sears retail stores;

■ Aluminum Oxide Sheets With Paper Backing (1/4 Sheet)

X-Fine, Fine, Medium, Coarse

■ Pressure-sensitive Adhesive, Paper Backed Sheets (1/4 Sheet)

X-Fine, Fine, Medium, Coarse

■ The Following Standard 4-1/2 in. X11 in. Sanding Sheets Can Be Cut To Fit The Sander

X-Fine, Fine, Medium, Coarse

WARNING:

Current attachments and accessories available for use with this toot are listed above. Do not use any

attachments or accessories not recommended by the manufacturer of this tool. The use of attachments or acces­
sories not recommended can result In serious personal injury.

13

Advertising