Service and adjustments – Craftsman 917.255520 User Manual
Page 23
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
SERVICE AND ADJUSTMENTS
TO REPLACE FUSE (See Fig. 29)
Replace with 30 amp automotive-type plug-in fuse. The
fuse holder is located in the engine compartment, directly
in front of the dash.
TO REPLACE HEADLIGHT BULB
•
Raise hood.
•
Pull bulb holder out of the hole in the backside of the
grill.
•
Replace bulb in holder and push bulb holder securely
back into the hole in the backside of the grill
•
Close hood.
INTERLOCKS AND RELAYS
Loose or damaged wiring may cause your tractor to run
poorly, stop running or prevent it from starting.
•
Check wiring. See eiectrical wiring diagram in Repair
Parts section of this manual,
TO REMOVE HOOD, GRILL AND SIDE PAN
ELS (See Fig's. 30 and 31)
•
•
Raise hood.
•
Unsnap headlight wire connector,
•
Stand at side of tractor. Grasp hood and tilt forward
and lift off hinge brackets.
- To re install,slide hood pivot rod Into slot in hinge
brackets, and carefully reinstall hood springs.
23