Craftsman 137.218250 - Manual (Page 9)

ASSEMBLY AND ADJUSTMENTS
ASSEMBLY INSTRUCTIONS
A WARNING
For your own safety, never connect plug to power source
outlet until all assembly steps are complete, and you have
read and understood the safety and operating instructions.
LEG SET (FIG. A)
1, Separate all parts and group by size and style.
NOTE: Finger tighten bolts and nuts when joining
parts.
2
.
3.
4.
5.
6
.
7.
8
.
9.
Use bolts (1), washers (2), and nuts (3) to assemble
the leg set parts.
Attach a leg (4) to the long top bracket (5). Attach the
next leg to the opposite end of the top bracket.
Repeat this assembly for the opposite side of the
leg set.
Attach the completed leg set assemblies to the short
top brackets (6). Repeat on the opposite side.
Insert bolt (7) into the recessed hole of the foot pad (8).
Insert into the teg flange hole and tighten, using
washer (9) and nut (10). Repeat for the three other
legs.
Attach the bottom brackets (11) between each leg.
Place the leg set on a level surface and tighten all
nuts and bolts.
1 .
SAW TO LEG SET (FIG. B)
1. Before mounting the blade guard, the rip fence and
miter gauge to the saw top, invert the saw table so that
it is facing the floor.
Position the leg set upside down on the saw base.
Match the holes of the stand to the holes on the
bottom flange of the saw base.
Secure the leg set to the saw base using bolts,
washers, and nuts.
When all bolts and nuts are tightened, carefully set the
saw in its upright position.
Position the saw on a clean, level surface.
2
.
3.
4.
5.
6 .
Fig.B
Leg set
mounting hole
Saw base
hole