Craftsman 536.881130 - Manual (Page 9)

ASSEM BLY
Cotter Pin
Figure 8
ASSEMBLE SNOW CHUTE
1. Remove back carriage bolt. See
Figure 7.
2. Tilt chute back into operating posi­
tion. See Figure 8 .
3. Replace carriage bolt from inside of
chute.
4. Replace flat washer and nylon lock­
nut on outside of flange.
5. Tighten carriage bolt securely.
NOTE: Check all carriage bolts in
flange for tightness. DO NOT over­
tighten.
NOTE: If the cables have become dis­
connected, reinstall springs as shown in
Figure 9.
CONNECT REMOTE CHUTE
1, Push remote chute control lever into
"Chute Deflector Up” position.
Feed “Z” fitting through hole in re­
mote chute bracket. See.
Snap remote chute control cable
into remote chute bracket. See.
Connect “Z" fitting into remote chute
control bracket. See.
Push remote chute control lever into
“Chute Deflector Down" position.
Cut tie strap on chute deflector. See
Figure.
SPEED SELECT LEVER
2 .
3.
5.
6
.
1 .
2
.
F-001060J
Cut plastic tie securing speed select
lever assembly to the shifter brack­
et. See Figure 10.
Remove locknut, washer, spring,
and the boit. See Figure 12,