Craftsman 315.212220 - Manual (Page 31)

ACCESSORIES
CLAMPING WORKPIECE TO THE FENCE
■ Insert the grooved end of the clamp extension rod
as far as it will go into the front hole of the clamp
support. This will allow the clamp to press the
workpiece against the fence. See Figure 44.
CLAMP WORKPIECE TO THE FENCE Fig. 44
■ Secure the clamp extension rod with a screw.
■ Slide the clamp assembly onto the clamp exten­
sion rod and secure with a screw.
Note: The clamp assembly can be slid forward or
backward on the clamp extension rod as
needed by ioosening the screw.
■ Turn the knob to secure and free the workpiece
against the fence.
■ Securely tighten all screws on the clamp before
each use.
■ Before making a cut, always check the blade and
blade guard clearance over and around the miter
clamp.
A WARNING: Make sure the saw blade or blade
guard will not hit the work clamp assembly when
cutting miter and bevel cuts. Failure to heed this
warning could result in serious personal injury.
CLAMPING WORKPIECE TO THE SAW
TABLE
■ Insert the grooved end of the clamp extension rod
into the back, top hole of the clamp support. This
will allow the clamp to press the workpiece against
the saw table.
See Figures 42 and 45.
CLAMP
EXTENSION ROD
SCREWS
CLAMP SUPPORT
CLAMP WORKPIECE TO THE SAW TABLE
Fig. 45
■ Align the groove in the clamp extension rod with
the screw hole, and secure the rod with a screw.
■ Slide the clamp assembly onto the clamp exten­
sion rod and secure with a screw.
Note: The clamp assembly can be slid forward or
backward on the clamp extension rod as
needed by ioosening the screw.
■ Turn the knob to secure and free the workpiece
against the saw table.
■ Securely tighten all screws on the clamp before
each use.
■ Before making a cut, always check the blade and
blade guard clearance over and around the miter
clamp.
A WARNING: Make sure the saw blade or blade
guard will not hit the work clamp assembly when
cutting miter and bevel cuts. Failure to heed this
warning could result in serious personal injury.
31