Craftsman 917.271110 User Manual

Page 16

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Advertising
background image

mix oil with gasoline. Purchase fuel in
quantities that can be used within 30
days to assure fuel freshness.

IMPORTANT: When operating in tempera­

tures below 32°F(0'’C), use fresh, clean
winter grade gasoline to help insure good
cold weather starting.

A.WARNING: Experience indicates that

alcohol blended fuels (called gasohol or

using ethanol or methanol) can attract

moisture which leads to separation and

formation of acids during storage. Acidic

gas can damage the fuel system of an

engine while in storage. To avoid engine
problems, the fuel system should be emp­

tied before storage of 30 days or longer.

Drain the gas tank, start the engine and
let it run until the fuel lines and carburetor

are empty. Use fresh fuel next season.
See Storage Instructions for additional

information. Never use engine or carbure­

tor cleaner products in the fuel tank or per-

2

anent damage may occur.

kCAUTION: Fill to bottom of gas tank

filler neck. Do not overfill. Wipe off any
spilled oil or fuel. Do not store, spill or use

gasoline near an open flame.

TO START ENGINE
When starting the engine for the first time

or if the engine has run out of fuel, it will
take extra cranking time to move fuel from
the tank to the engine.
• Sit on seat in operating position,

depress clutchA>rake pedal and set
parking brake.

• Place gear shift lever in neutral (N) posi­

tion.

• Move attachment clutch to “DISEN­

GAGED” position.

• Move throttle control to choke position.

Note: Before starting, read the warm and

cold starting procedures below.

• Insert key into ignition and turn key

clockwise to “START” position and

release key as soon as engine starts.

Do not run starter continuously for more

than fifteen seconds per minute. If the
engine does not start after several
attempts, move throttle control to fast
position, wait a few minutes and try
again. If engine still does not start,

move the throttle control back to the

choke position and retry.

WARM WEATHER STARTING (50" F

AND ABOVE)

• When engine starts, move the throttle

control to the fast position.

• The attachments and ground drive can

now be used. If the engine does not

accept the load, restart the engine and

allow it to warm up for one minute using

the choke as described above.

COLD WEATHER STARTING ( 50" F
AND BELOW)

• When engine starts, allow engine to run

with the throttle control in the choke

position until the engine runs roughly,

then move throttle control to fast posi­
tion. This may require an engine warm­

up period from several seconds to sev­

eral minutes, depending on the temper­
ature.

• The attachments can also be used dur­

ing the engine warm-up period.

NOTE: If at a high altitude (above 3000

feet) or in cold temperatures (below 32 F)
the carburetor fuel mixture may need to be

adjusted for best engine performance.
See TO ADJUST CARBURETOR” in the

Service and Adjustments section of this
manual.

MOWING TIPS

• Tire chains cannot be used when the

mower housing is attached to tractor.

• Mower should be properly leveled for

best mowing performance. See TO
LEVEL MOWER HOUSING” in the
Service and Adjustments section of this
manual.

• The left hand side of mower should be

used for trimming.

• Drive so that clippings are discharged

onto the area that has been cut. Have

the cut area to-lhe right of the tractor.
This will result in a more even distribu­
tion of clippings and more uniform cut­
ting.

r

16

Advertising