Craftsman 917.276361 User Manual
Page 30
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
TROUBLESHOOTING CHART:
See appropriate section in manual unless directed to Sears service center
PROBLEM
CAUSE
CORRECTION
Will not start
1. Out of fuel.
1. Fill fuel tank.
2. Engine not “CHOKED”
2. See “TO START ENGINE”
properly.
in Operation section.
3. Engine flooded.
3. Wait several minutes before
attempting to start.
4. Bad spark plug.
4. Replace spark plug.
5. Dirty air filter.
5. Clean/replace air filter.
6. Dirty fuel filter.
6. Replace fuel filter.
7. Water in fuel.
7. Empty fuel tank and carbure
tor, refill tank with fresh
gasoline and replace fuel
filter.
8. Loose or damaged wiring.
8. Check all wiring.
9. Carburetor out of
9. See “To Adjust Carburetor”
adjustment.
in Service and Adjustments
section.
10 Engine valves out of
10.Contact a Sears or other
adjustment.
qualified service center.
11. Extreme Cold Conditions
11. See “To start engine” in
operation section.
Hard to start
1. Dirty air filter.
1. Clean/replace air filter.
2. Bad spark plug.
2. Replace spark plug.
3. Weak or dead battery.
3. Recharge or replace battery.
4. Dirty fuel filter.
4. Replace fuel filter.
5. Stale or dirty fuel.
5. Empty fuel tank and refill tank
with fresh, clean gasoline.
6. Loose or damaged wiring.
6. Check all wiring.
7. Carburetor out of
7. See “To Adjust Carburetor”
adjustment.
in Service and Adjustments
section.
8. Engine valves out of
8. Contact a Sears or other
adjustment.
qualified service center.
Engine will not
1. Brake pedal not
1. Depress brake pedal.
turn over
2.
depressed
Attachment clutch is
2. Disengage attachment
engaged.
clutch.
3. Weak or dead battery.
3. Recharge or replace battery.
4. Blown fuse.
4. Replace fuse.
5. Corroded battery terminals.
5. Clean battery terminals.
6. Loose or damaged wiring.
6. Check all wiring.
7. Faulty ignition switch.
7. Check/replace ignition
switch.
8. Faulty solenoid or starter.
8. Check/replace solenoid or
starter.
9. Faulty operator presence
9. Contact a Sears or other
switch(es).
qualified service center.
Engine clicks but
1. Weak or dead battery.
1. Recharge or replace battery.
will not start
2. Corroded battery terminals.
2. Clean battery terminals.
3. Loose or damaged wiring.
3. Check all wiring.
4. Faulty solenoid or starter.
4. Check/replace solenoid or
starter.
30