Craftsman 917.276030 - Manual (Page 18)

MAINTENANCE
MAINTENANCE SCHEDULE
FILL IN OATES
AS YOU COMPLETE
check Brake Citation ✓ ✓
Check Tire Pnessuro ✓ ✓
Check Operator
P
ressnce and
Interlodf Systems ✓
Check lor Loose Fasteners
✓ ✓ s ✓
ShatpsrVRsplaos Mon«r Blades
LubdcaSon Chart ✓ ✓
Chock Battery Level
✓ 4
Clean Battery and Terminals ✓ ✓
Chock Transaxlo Ccx^ing
✓
Check V-Belts
✓
Check Engine OH Level
f/ ✓
Change Engine Oil (wi№ oil fitter)
✓ ..2 ✓
Change Engine Oil (without oil filler)
✓
Clean Air FIHor
✓ 2
Cfean Air Screen
✓ 2
Inspect Mufflor/^ark Arresler
✓
Replace Oil Fitter (If equipped) I/.2
Clean Engine Cooling Fins
✓ 2
Replace Spark Rug
✓ ✓
Replace Air Filler Paper Cartridge
✓ 2
Repiaco Fuei Filler
1 < CHange more o^leo wt>er> undar a heavy load Of
in high ambiem temperatures.
2 - Ser\Ace more often when operating in dirty or dusty conditions.
GENERAL RECOMMENDATIONS
The warranty on this tractor does not
cover items that have been subjected to
operator abuse or negligence. To receive
full value from the warranty, operator
must maintain tractor as instructed in this
manual.
Some adjustments will need to be made
periodically to properly maintain your
tractor.
All adjustments in the Service and Adjust­
ments section of this manual should be
checked at least once each season.
• Once a year you should replace the
spark plug, clean or replace air filter,
and check blades and belts for wear.
A new spark plug and clean air filter
assure proper air-fuel mixture and help
your engine run better and last longer.
BEFORE EACH USE
1
.
2
.
3.
4,
a - UKU3IW more onon wnon mowing m sanay soil.
4 - Not rot^ired if equipped with maintenanc^free battery.
5 - Tighlon Iron! axte pivot boit to 35 it.-lbs. maximum.
Do not ovortightian,
LUBRICATION CHART
® Tie Ro^Ball Joints
® Spindle
Zerk
<2) Spindle
Zerk
SyFront Wheel
Searing Zerk
® Engine
5.
Check engine oil level.
Check brake operation.
Check tire pressure.
Check operator presence and
interlock systems for proper operation.
Check for loose fasteners.
®Front Wheel
Bearing
Zerk
¡^Steering
Sector '
Gear
Teeth
ODCheck/
Add
Transaxle
Fluid
<i> SAE 30 or 10w30 motor oil
® General Purpose Grease
<3) Refer to Maintenance “ENGINE” Section
® Spra.y silicone lubriant (Move Boots to
Lubricate)
IMPORTANT: Do not oil or grease the
pivot points which have special nylon
bearings. Viscous lubricants will attract
dust and dirt that will shorten the life of
the self-lubricating bearings. If you feel
they must be lubricated, use only a dry,
powdered graphite type lubricant sparingly.
^8