To remove/replace the throat plate, Assembl, See figure 10 – Craftsman 315.284610 User Manual
Page 18: See figure 11
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
ASSEMBL
i
J
■ Hold the nylon nut securely and turn the screw
counter- clockwise to remove the nut completely.
NOTE: Do not remove the screw from the handle.
■ Place the nylon nut into the recessed hole on the back
of the height/bevel adjusting handwheel and hold in
place.
■ Slide the handle, screw, and washer into the hole on
the height/bevel adjusting handwheel.
■ Using a flathead screwdriver, turn the screw clockwise
and tighten in place.
TO INSTALL THE HANDLE
See Figure 9.
SCREW
NYLON
HEIGHT / BEVEL
NUT
ADJUSTING HANDWHEEL
Fig. 9
TO INSTALL THE LOCKING LEVER
See Figure 10.
■ Slide the locking lever over the exposed end of the rip
fence making certain the handle is inserted as far as
possible.
■ Align the holes in the rip fence and the holes in the
lever. Secure using the screws.
LOCKING
LEVER
SCREWS
RIP
FENCE
Fig. 10
TO REMOVE/REPLACE THE THROAT PLATE
See Figure 11.
■ Lower the blade by turning the height/bevel adjusting
handwheel counterclockwise.
■ To remove the throat plate, place your index finger in
the hole and lift the front end pulling the throat plate
out toward the front of the saw.
■ To reinstall the throat plate, slip the tab into the slot at
the back of the saw and push down to secure in place.
THROAT
PLATE
SPREADER / RIVING
KNIFE
Fig. 11
18