Craftsman 917.379480 User Manual

Page 17

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Advertising
background image

OTHER

• Do not store gasoline from one season

to another.

• Replace your gasoline can if your can

starts to rust. Rust and/or dirt in your
gasoline will cause problems.

• If possible, store your unit indoors and

cover it to give protection from dust and

dirt.

• Cover your unit with a suitable protec­

tive cover that does not retain moisture.

Do not use plastic. Plastic cannot

breathe which allows condensation to

form and will cause your unit to rust.

IMPORTANT: Never cover mower while

engine and exhaust areas are still warm.

^CAUTION: Never store the lawn mower

with gasoline in the tank inside a building
where fumes may reach an open flame or
spark. Allow the engine to cool before
storing in any enclosure.

TROUBLESHOOT

NG CHART

PROBLEM

CAUSE

CORRECTION

Does not start

1. Dirty air filter.

1. Clean/repiace air filter.

2. Out of fuel.

2.

Fin

fuel t£mk.

3. Stale fuel.

3. Drain tank and refill with

fresh clean fuel.

4. Water in fuel.

4. Drain fuel tank and

cartxjretor and refill tank
with fresh gasoline.

5. Spark plug wire is

disconnected.

5. Connect wire to plug.

6. Bad spark plug.

6. Replace spark plug.

7. Loose blade or broken blade

adapter.

7. Tighten blade bolt or

replace blade adapter.

8. Control bar in released

position.

8. Depress control bar to

handle.

9. Control bar defective.

9. Replace control bar.

Loss of power

1. Rear of lawn mower housing

or cutting blade dragging
in heavy grass.

1. Set to "Higher CuT

position.

2. Cutting too much grass.

2. Set to “Higher Cuf

position.

3. Dirty air fitter.

3. Oean/replace air filter.

4. Buildiqs of grass, leaves,

and kash under mower.

4. Clean underside of mower

housing.

5. Too much oil in engine.

5. Ched( oil level.

6. Walking speed too fast

6. Cut at slower walldng

speed.

Poe»* cut - uneven

1. Worn, bent or loose blade.

1. Replace blade. Tighten

Na^ bolt.

2. Wheel heights uneven.

2. Set all wheels at ssmrie

height

3. Low engine speed

3. Contact an authorized center/

department

4. Buildup of grass, leaves

and trash under mower.

4. Clean underside of

mower housing.

17

Advertising