Craftsman 536.885210 User Manual

Page 10

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Advertising
background image

SNOW THROWING TIPS
• This snow thrower will propel itself

forward when the handle is raised

enough to cause the auger blades to

contact the ground. The auger should
stop when auger control bar is released.

If it does not, refer to Adjust Auger

Control Cable paragraph on page 12.

• For most efficient snow throwing, turn the

discharge chute deflector to throw snow
downwind, and slightly overlap each

swath. In light snow take up to a full cut
and in heavy snow take less than a full
cut.

• The distance snow will be discharged can

be adjusted by moving the discharge
chute deflector. Raise the deflector for
more distance or lower the deflector for
less distance.

• In windy conditions, lower the chute

deflector to direct discharged snow close

to the ground where it is less likely to

blow into unwanted areas.

• Keep the area to be cleared free of

stones, toys and other foreign objects for
safety and to prevent damage to the
snow thrower.

• Do not use the auger propeliing feature

when clearing gravel or crushed rock

driveways. Move the handle down to
raise the auger slightly.

• The allowable forward speed of the snow

thrower is dependent on the depth and
weight of the snow. Experience wilt
establish the most effective method of

using the snow thrower under different

conditions.

DRY AND AVERAGE SNOW

• Snow up to eight inch depth can be

removed rapidly and easily by walking at

a moderate rate. For snow or drifts of a
greater depth you may find it desirable to

slow your pace to allow the discharge
chute to dispose of the snow as rapidly
as the auger receives the snow.

• Plan to have the snow discharged in the

direction the wind is blowing.

WET PACKED SNOW
• Move slowly into snow of this condition.

The greater the depth, the slower you
should go. When it appears that the wet,
packed snow is causing the auger to slow
down and the chute to clog, back off and
begin a series of short jabs into the snow.

These short back and forth, 4 to 6 inch,

jabbing motions will "belch" the snow

from the chute.

SNOW BANKS AND DRIFTS

• In snow of greater depth than the unit,

use the jabbing technique described
above. Turn the discharge chute away

from the snow bank. More time will be

required to remove snow of this type than
level snow.

HORSE POWER:

5HP

DISPLACEMENT:

8.46 cu. in.

GASOLINE CAPACITY: 1.62 quart

(unleaded)

FUEL70IL MIX RATIO: 40:1

(3.2 oz. of air­

cooled engine 2
cycle oil specified

for 40:1 per 1 gal. of

gas)

SPARK PLUG:

Champion HCJ8Y
(Gap .030) or
Equivalent

10

Advertising