Craftsman 917.271061 User Manual

Page 16

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Advertising
background image

MOWING TIPS

• Tire chains cannot be used when the

mower housing is attached to tractor.

• Mower should be properly leveled for

best mowing performance. See “TO

LEVEL MOWER HOUSING” in the

Service and Adjustments section of
this manual.

• The left hand side of mower should be

used for trimming.

• Drive so that clippings are discharged

onto the area that has been cut. Have
the cut area to the right of the tractor.
This will result in a more even distribu­
tion of clippings and more uniform
cutting.

• When mowing large areas, start by

turning to the right so that clippings will

discharge away from shrubs, fences,

driveways, etc. After one or two

rounds, mow in the opposite direction
making left hand turns until finished.

• If grass is extremely tall, it should be

mowed twice to reduce load and
possible fire hazard from dried
clippings. Make first cut relatively
high; the second to the desired height.

• Do not mow grass when it is wet. Wet

grass will plug mower and leave
undesirable clumps. Allow grass to
dry before mowing.

• Always operate engine at full throttle

when mowing

to assure better mowing

performance and proper discharge of
material. Regulate ground speed by
selecting a low enough gear to give
the mower cutting performance as well
as the quality of cut desired.

• When operating attachments, select a

ground speed that will suit the terrain
and give best performance of the
attachment being used.

MULCHING MOWING TIPS
IMPORTANT:

For best performance,

keep mower housing free of built-up

grass and trash. Clean after each use.
• The special mulching blade will recut

the grass clippings many times and

reduce them in size so that as they fall
onto the lawn they will disperse into

the grass and not be noticed. Also, the

mulched grass will biodegrade quickly

to provide nutrients for the lawn.

Always mulch with your highest
engine (blade) speed as this will
provide the best recutting action of the
blades.

• Avoid cutting your lawn when it is wet.

Wet grass tends to form clumps and
interferes with the mulching action.
The best time to mow your lawn is the
early afternoon. At this time the grass
has dried and the newly cut area will
not be exposed to the direct sun.

• For best results, adjust the mower

cutting height so that the mower cuts
off only the top one-third of the grass
blades. For extremely heavy mulching,

reduce your width of cut on each pass

and mow slowly.

• Certain types of grass and grass

conditions may require that an area be

mulched a second time to completely
hide the clippings. When doing a

second cut, mow across or perpen­

dicular to the first cut path.

• Change your cutting pattern from week

to week. Mow north to south one week
then change to east to west the next

week. This will help prevent matting
and graining of the lawn.

A Kdt .

^ A. ,

.

Max 1/3"

16

Advertising