Installing the cutting bit – Craftsman 320.28190 User Manual
Page 16
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
INSTALLING AND REMOV
ING THE CUTTING BIT (Figs,
3, 4 and 4a)
INSTALLING THE CUTTING BIT
1. Turn router motor off and
unplug from power source.
2. Remove router motor from
fixed base.
NOTE: See instructions on
removing and installing the
router motor in the fixed
base on page 18.
3. Set the router motor up
side down on its top cap,
with colleVnut pointing up.
4. Press spindle lock button
to engage and lock the
spindle shaft and collet/nut
(Fig.3).
5. Place the wrench on the
collet/nut and turn coun
ter-clockwise and loosen
coilet/nut slightly to accept
cutting bit shank.
6. Insert cutting bit shank into
collet/nut assembly as far
as it will go, then back the
shank out until the cutters
are approximately 1/8 to 1/4
inch away from the face of
the collet/nut (Fig. 4,4a)
7. With cutting bit inserted
and spindle lock button
pressed in engaging shaft,
place wrench on coilet/nut
and turn clockwise until
router cutting bit and col
let/nut are firmly tightened.
28190 Manual Revised 070409
Page 16