Assembly – Craftsman 315.175320 User Manual
Page 5
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
ASSEMBLY
WARNING:
The router should never be
connected to a power supply when you are
assembling parts, making adjustments, cleaning,
performing maintenance, or when the tool is not in
use. Disconnecting the tool prevents accidental
starting that could cause serious injury.
INSTALLING THE VACUUM ATTACHMENT
See Figure 2.
Follow these steps to install the vacuum attachment.
1. Unplug the router.
A WARNING:
Failure to unplug the tool could result
in serious injury due to accidental starting.
2. Place the vacuum attachment on the base as
shown.
3. Secure the attachment with the screws provided.
INSTALLING THE ROUTER MOTOR IN THE
BASE
See
Figure 3.
Follow these steps to install the router motor in the
base.
1. Unplug the router.
WARNING:
Failure to unplug the tool could result
in serious injury due to accidental starting.
2. Place the base on a flat surface.
3. Loosen the locking knob.
A CAUTION:
Do not tighten the locking knob
without the motor installed in the base. Failure to
heed this caution may result in permanent damage
to the locking mechanism.
4. Align the slot on the motor housing with the groove
on the base.
5. Depress and hold the spindle lock button.
6. Slide the motor housing into the base.
7. Tighten the locking knob.
GROOVE ON
THE BASE
LOCKING
KNOB
Fig.3