Craftsman 706.596690 - Manual (Page 13)

Unplug work surface cord from back of
roll-away.
Remove and save back retaining clip.
Disconnect chain inside back of roll-
away. (Move chain toward large round
part of slot. Pull out to remove.)
Remove the work surface. (See
drawer removal instructions.)
Retaining
Installation
• To reinstall, carefully align the slides
and push the work surface into the unit
until the work surface stops.
• Depress release tabs in back corners
of the extendable work surface.
• Push the work surface into the unit to
the fully retracted position.
• Extend work surface far enough to
gain access to connections in back.
• Connect chain inside back of roil
away. (Insert chain into the large
round part of the slot. Slide chain to
small end of slot.)
• Insert retaining clip to hold chain in
place.
• Plug work surface cord into back of
roll-away.
• Reconnect power to the unit. (See:
Connecting power.)
• Check work surface and task lighting
for proper operation.
• Reinstall drawers.