Craftsman 486.245992 User Manual

Page 3

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Advertising
background image

▲

CAUTION!

Muffler is hot! Allow engine to

cool down before proceeding with bumper

installation.

STEP 1

: (SEE FIGURE 2)

•

Remove tractor hood. (Refer to tractor manual.)

•

Remove the browning shield as shown below.

STEP 2:

(SEE FIGURE 3)

• Insert a hex bolt (C) into the second mounting hole from

the front of the tractor frame and fully tighten a hex nut

(D) onto the bolt. Repeat on other side of tractor.

STEP 3:

(SEE FIGURE 4)

• Place plug (E) on a work bench or solid table and push

end of bumper down onto plug. Repeat for second

plug.

STEP 4:

(SEE FIGURE 5)

•

Spread ends of bumper enough to fit slots onto bolts in

rear mounting holes in tractor frame.

•

The bumper has three mounting holes. The rear hole

provides the most clearance while the forward holes
provide a neater appearance. Use a hole that provides
enough clearance for hood to stay in raised position
when opened. Insert a hex bolt (C) through tractor frame
and into desired mounting hole on each side of bumper
and secure with a hex nut (D).

IMPORTANT: Before

fully tightening nuts, be sure tractor

hood will stay in raised position when opened.

STEP

5: (SEE FIGURE 6)

• Replace the browning shield using the front screws you

removed in Step 1.

Advertising