Craftsman 247.889980 - Manual (Page 24)

SERVICE AND MAINTENANCE
CHANGING THE DECK ENGAGEMENT BELT CHANGING THE DECK TIMING BELT
AWARNING
Shut the engine off and remove ignition key before removing the
cutting blade(s) for sharpening or replacement. Protect your hands by
using heavy gloves when grasping blades and pulleys.
AWARNING
The V-belts found on your mower are specially designed to engage and
disengage safely. A substitute (non-OEM) V-belt can be dangerous by
not disengaging completely. For a proper working machine, use identi­
cal replacement belts as listed In parts list of this operator’s manual.
All belts on your mower are subject to wear and should be replaced if
any signs of wear are present. To change or replace the deck engage­
ment belt on your mower, proceed as follows:
1. Remove the cutting deck from the mower as instructed earlier in
this section.
AWARNING
Avoid pinching injuries. Never place your fingers on the Idler spring or
between the belt and a pulley while removing the belt
2. Remove the belt cover as Instructed earlier In this section. Refer
to Figure 20 on page 19.
3. Remove the belt keeper as Instructed earlier In this section. Refer
to Figure 21 on page 19.
4. Loosen, but not remove, the nut and bolt which secures each
deck Idler pulley. See Figure 30.
Figure 30
5. Remove the belt from around all pulleys.
6. Route the new belt as Illustrated In Figure 30.
7. Retighten the nuts and bolts which secure each Idler pulley.
8. Reattach the belt keeper and belt cover.
Several components must be removed and special tools used In
order to change the mower deck's timing belt. See your Sears or
other qualified service dealer to have the deck timing belt replaced.
CHANGING THE TRANSMISSION DRIVE BELT
Several components must be removed and special tools used in order
to change the mower's transmission drive belt. See your Sears or other
qualified service dealer to have the transmission drive belt replaced.
FUSE
AWARNING
Before servicing, repairing, or inspecting, always disengage blades,
stop engine and remove key to prevent unintended starting.
A 20 Amp fuse is installed In your mower's wiring harness to protect
the mower’s electrical system from damage caused by excessive
amperage.
If the electrical system does not function, or your mower's engine will
not crank, first check to be certain that the fuse has not blown. It Is
located near the battery.
A CAUTION
Always use a replacement fuse with the same amperage capacity as
the blown fuse.
24