Craftsman 917.254611 - Manual (Page 26)

TROUBLE SHOOTING
m- Use fresh fuel and adjust Carburetor
m
Drän and replace oil for proper temperature
NOUGH1B isr Check Fuse, Switch and Wire Connections. Replace Headlight Bulbs
«r Replace Switch
WONT CHARGE cr Check Fuse for fault and replace
m Replace Battery
Replace Regulator
Replace Altarnator
ENGINE WILL NOT SHUT DOWN
WHEN OPERATOR LEAVES SEAT NOTE: Ibis tractor is equipped with an operator presence sensing
system. Any attempt by the operator to leave the seat with the engine
running and the mower clutch engaged will shut down the engine.
Check all Wire connections
mt Check Seat Switch
m- Chedc Operator Presence Relay
UNSATISFACTORY MOWER PERFORÎWANCE
UNEVEN DISTRIBUTION OF CUPPINGS tsr Place Throttle Control in “FAST position
Check air pressure in Tires
m- Check front-to-rear and side-to-side Mower adjustment
«r
Use a sbwer ground speed
Replace Mower Blades
mt Reinstall Mower Blades with Sharp Edge down
Replace with proper Mower Blades
vsr Readjust Mower Drive Belt
m- Clean underside of Mower Deck
MOWER BLADES WILL NOT ROTATE Correct Clutch mechanism Interference
Install new Mower Drive Belt
XSt Adjust Mower Drive Belt
fiSr Replace frozen Mandrel
fSBf Replace frozen Idler Pulley
EXCESSIVE MOWER VIBRATION m- Replace bent or unbalanced Blades
ifflr Replace Mandrel, Replace Deck
WINDROWING STRIPPING OH
DROPPING OF GRASS CUPPINGS «0^ Set Throttle for maximum engine speed
m- Let grass dry out
for Clean underside of Mower Deck
w
Readjust Mower front-to-rear and side-to-side
m- Replace Blades
UNEVEN CUT OR SCALPING BT Readjust Mower front-to-rear and side-to-side
sst Replace Blades
Ifflr Replace bent Mandreljs}
26