Support tube assembly, Intake funnel assembly, Warning – Craftsman 152.213351 User Manual
Page 11
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
2. Insert a 5/16-18 x 5/8" hex head screw (C) through
the exhaust flange, exhaust flange gasket and the
exhaust port flange. See figure 8.
3. Thread 5/16-18 flange hex nut (D) onto the 5/16-18
X
5/8" hex head screw, do not tighten completely.
See figure 8.
4. Repeat Steps 1,2, and 3 for the remaining holes.
Tighten all hardware.
SUPPORT TUBE ASSEMBLY
^WARNING
MAKE CERTAIN THE DUST COLLECTOR IS
DISCONNECTED FROM THE POWER SOURCE.
Fig. 9
1. Place support tube clamp (A) over lower support
tube holder (B). See figure 9.
2. Insert the lower support tube (C) into the lower
support tube holder and tighten support tube clamp.
See figure 10.
3. Place support tube clamp over top of lower support
tube.
INTAKE FUNNEL ASSEMBLY
A
warning
MAKE CERTAIN THE DUST COLLECTOR IS
DISCONNECTED FROM THE POWER SOURCE.
Fig. 11
1. Align the two holes in the Intake support brace (A)
with the two holes in the intake funnel (B).
See figure 11.
11