Clarion pro audio vrx 630 - Manual (Page 25)

VRX630
29
English
Owner
’s manual
Setting the TV diver
∗
This function is enabled only when the panel is
open.
∗
Normally use the TV diver with the “ON” position.
You can change the reception setting for the TV
antenna connected to the TV tuner.
1. Press the ADJ button * to switch to the ad-
justment selection display.
2. Operate the JOYSTICK ¡ upward or down-
ward to select “TV DIVER”.
3. Operate the JOYSTICK ¡ rightward or left-
ward to select “ON” or “OFF” and press the
ENT at the center of the JOYSTICK
¡ to set
the selected reception setting.
● ON:
Sets reception emphasizing the visual.
● OFF:
Sets the diver setting to OFF.
4. Press the ADJ button * to return to the pre-
vious mode.
Adjusting the brightness and tone
of color
Notes:
• This operation is available only when the car is
stopped and the parking brake is applied.
• This function is not available when the display is
stored.
• The HUE setting can be adjusted only when the
NTSC mode is selected.
1. Press the BND button % to switch to the ad-
justment selection display.
2. Operate the JOYSTICK ¡ upward or down-
ward to select the option “MONI ADJ” (by mov-
ing the cursor).
3. Press the ENT at the center of the JOYSTICK
¡ .
4. Operate the JOYSTICK ¡ rightward or left-
ward to select “BRIGHT”,“COLOR” or “HUE”
(by moving the cursor).
● “BRIGHT“:
Adjust the brightness of the display.
● “COLOR“:
Adjusts the color saturation.
● “HUE“:
Adjusts the tone of color (red is emphasized
or green is emphasized.)
5. Operate the JOYSTICK ¡ upward or down-
ward to adjust a level.
TV Operations
6. When the adjustment is made, operate the
JOYSTICK ¡ rightward or leftward to move
the cursor to “MENU”. Then press the ENT at
the center of the JOYSTICK
¡ to return to
the adjustment selection display.
Changing over display size
∗
This function is available only when the panel is
open.
Notes:
• This function is not available while you are driving.
• Switch to the VTR/TV/DVD video mode you see.
1. Press the WIDE button 7 to change over the
monitor display size. Each time you press
the WIDE button
7 , the monitor display size
changes in the following order:
“NORMAL” ➜ “WIDE” ➜ “F. WIDE” ➜
“CINEMA” ➜ “NORMAL”
● “NORMAL”: (normal display)
There is a black area at both right and left
ends of a display. In case of normal TV
broadcasting (4:3), the image can be shown
without being cut or deformed.
● “WIDE”: (wide mode)
The image at right and left ends in a display
elongates horizontally.
● “F. WIDE”: (full wide mode)
The whole image elongates horizontally.
● “CINEMA”: (cinema mode)
The image at both top and bottom in a dis-
play disappears.
Notes:
• When a normal 4:3 size image, not being a wide
one, is viewed by displaying it fully on a wide moni-
tor display in a wide mode or a full-wide mode, a
part of the peripheral image will be lacking or de-
formed. In deference to the intention of producer,
an original image can be viewed in a normal mode.
• During superimposed display, it becomes a full-wide
mode.