Alumax 350 Deluxe - Manual (Page 9)

G03711139
6-9-2014
Page 8
Neatly caulk each end of the tub track [ A] where
it meets the wall jambs [ B] and the interior edge of the
wall jambs as shown. Run a bead of caulking along the
interior edge of the tub track.
NOTE: The caulking should be allowed to cure for twenty-
four hours before using your new bath enclosure.
13
TUB
TRACK
WALL
JAMB
The Care and Cleaning of your new A
LUMAX
Bath Enclosure. The simplest and preferred
method of cleaning your unit is by washing it with clean water and drying with a soft cloth.
If soil is still present after drying, a non-abrasive cleanser with a pH of seven to eight may
be used. Comet Bathroom Cleaner
® has been tested and is recommended by the Bath
Enclosure Manufacturers Association (BEMA). Do not use scouring pads, sharp instruments,
or acid-based cleansers to clean the unit.
Thank you for choosing an A
LUMAX
Bath Enclosure. Please take a moment to complete
and return the enclosed Customer Response Card. The information you provide helps us
improve the quality of our products and provide better service to you, our customer.
To install the optional bottom bumper [ U],
remove the bottom wall jamb screw closest to the shower
head. Insert the screw through the hole in the center of
the bottom jamb bumper and replace it in the wall jamb,
with the leg pointing inside of the enclosure. Re-tighten
the screw.
12a