Alumax 738 - Manual (Page 4)

EPH-N00-06002
1-24-97
Page 4 of 8
Run two beads of caulk inside the penciled
marks on the shower sill. Place the curb [A] in the
exact position marked in Step #2 and seat it firmly
in the caulking.
NOTE: Improper caulking will result in leaks.
1
NOTE: The 738 unit may be installed without
using the sloped curb [A] provided. Its use is
definitely recommended for positive water control
on shower sills with little or no slope.
Measure the wall to wall opening at the shower
sill and cut the curb to the exact length. File the
ends of curb as necessary to fit the corner contours
of the enclosure. Place the curb on the shower sill
with the raised portion to the exterior of the
enclosure. Make sure the curb is centered on the
sill and lightly mark its position on the sill with a
pencil. Remove the curb from the sill.
The A LUMAX 738 Pivot Shower Door is
completely reversible and may be installed pivot-
right or pivot-left. Using the diagram, determine
the correct position for your installation. For
maximum waterproofing, the pivot jamb should
always be opposite the shower head. These
instructions depict a pivot-left installation.
CAUTION: For safety, the door must always
open outward.
2
3