Alumax L-422 - Manual (Page 16)

SUPPORT BAR INSTALLATION
3c
3a
3
3a. Take apart the end component (A) of the
support bar with the provided Allen Key
.
3b. Transfer the position of the bottom clip (8)
to the back wall. At 82” from the threshold
mark the position (center of the cylinder )
for the support bar end component (A)
mounting
3c. Drill the back wall using a Ø1/4”drill bit.
3d.
3e.
Apply a bead of silicone in each hole and
insert the wall plug.
Proceed to fasten the wall end components
(A) onto the wall.
To ease subsequent installation on the front
panel. Insert bar (7) in the component wall
(A) on a horizontal plane as shown.
Tighten the set screws.
3e
MIN 82” | MAX
. 82 1/4”
DIST
ANCE FROM TOP OF THRESHOLD TO CENTER OF W
ALL END COMPONENT
WALL END COMPONENT
7
8
7
A
13
3d
3b
A
A
B
INSTALLATION MANUAL
B
301X, 302X, 421X, 422X, 421TBX, 422TBX