Arc Machines 207 - Manual (Page 43)

MODEL 207A AND 207A-1
OPERATION MANUAL
Doc. No. 740044
Rev F
SECTION V - OPERATION
5.7
SET UP FUNCTIONS
1. SET UP FUNCTIONS IN OPERATE MODE
3. HEAD CAL - This feature is used to calibrate Travel (rotation) speed of
the Weld Heads and MUST BE USED ANY TIME A CHANGE OF
WELD HEADS IS MADE. See Section 5.7 for operation.
4. REV - Pressing the F key under this will show the current software
REVISION installed. This can be important when discussing problems
or features with an AMI representative.
NOTE
The following are on the second SET UP screen and are accessed by pressing
NEXT SCREEN from the first SET UP screen.
5. PRINT EMM - Pressing the F key under this choice will create a Print
out of the LIBRARY contained in M-207-EMM Option (EMM must be
installed, see 8.3).
6. AMP - TIME - This feature allows the user to change the programmable
increments of LEVEL AMPS or LEVEL TIME from 000 (whole
numbers) to 000.0 (tenths).
NOTE
This is not on an individual WELD # basis. All WELD # will be
changed automatically. If a WELD # was originally programmed for
87.7 amperes and this is changed to whole numbers the WELD # when
accessed will then call for 87 amperes (it will drop the digit, not round
off).
7. ARC V FAULT - This feature can turn this FAULT ON or OFF. When
ON a STUB OUT will be created if the ARC VOLTAGE goes below 5V
or a HIGH VOLTS fault if the VOLTAGE goes over 20 V. However, in
manual welding these conditions can occur without anything being
wrong. THIS FEATURE NEEDS TO BE SET TO OFF FOR
MANUAL WELDING.
NOTE
The following are on the third SET UP screen (in operate mode) and are
accessed by pressing NEXT SCREEN from the second SET UP screen.
5.8