AVer NX8000 - Manual (Page 39)

32
Enable – Mark the check box to enable the System Controller function.
Model – Select model of the System Controller.
Port
– Select the com port that is connected with the System Controller. Click Setup to
configure com port value. The com port value is shown in below table:
Baud rate 9600
Data bits
8
Parity No
Stop bit
1
Flow control No
ID
– Set an ID for DVR server (0~99). This ID is a key for communicating between the
System Controller and the DVR server.
i
When the DVR server ID is X, the DVR server can be controlled by System Controller
irrespective of the DVR ID that is selected in System Controller.
(9) System Configuration
To configure the DVR system date, time and IP address.
Date/Time Setup
1. Select the Time Zone of DVR server located
2. Select the Month and Date. Click arrow button can switch to different month.
3. Adjust the Time by click spin box arrow button.
4. Click OK to save the configuration.
IP Setup