Canon IP4000 - Manual (Page 2)

Fig.3-1 Fig.3-2 Fig.3-3
4.Tube Adjustment and Positioning
a. Place T shape clip adhesive pad on the outside for the printer as shown (Fig.4-1)
b. Make sure the tubes are not twisted and are straight(Fig.4-2).
c. Adjust tubing between cartridge compartment and tube guide to correct length; allowing enough room for the
cartridge to move back and forth freely (Fig.4-3).
d. Turn on the printer and make sure the system moves smoothly.
Fig. 4-1 Fig. 4-2 Fig. 4-3
5.Refilling Ink
When the ink levels reach the indicator margin(sticker on the ink tank with red line)the ink tank system has
reached its low level line and needs to be refilled.
Follow these steps:
1. Gently remove the air breather plugs in order to have more filling room.
2. Remove plugs off of the filling hole and refill the proper color of ink into the corresponding ink tank,
(use towel to wipe off any spillage).
3. Make sure you use the specially designed inks Low Foam Ink for the CI System as they are specifically designed
for optimal results.
NOTE: When removing the CI System, remove cartridges and put tape or a napkin over dispensing hole.
Printer and ink tank MUST remain at the same level (not higher and not lower).
6.Attention:
1. After installing the CI System, do not remove the cartridges unless it is necessary, if cartridges are
removed, immediately place cartridges upside down with ink exit holes facing up to avoid leaking, if
cartridges are removed for more than an hour, please cover ink exit holes with tape.
2. When you are printing do not move the ink tank up or down, keep it stable and at the same level
as the printer.
3. Store at 15-35 degrees Celsius.
4. The ink and cartridge flow have been designed and tested to function as a system, we recommend you use