Salter Brecknell 308BP - Manual (Page 25)

xxv
B.2.3 RECOGNIZED HOST COMMANDS
“P” - This command is sent to the scale to print the indicated display. The scale will not
respond if the scale is in motion, positive overload or negative overload.
“Z” - This command is sent to the scale to zero the scale. The scale will not respond if the
scale is in motion, positive overload or negative overload.
“M” - This command is sent to the scale to add an entry to the accumulator (M+).
“R” - This command is sent to the scale to recall the contents of the accumulator (MR).
“C” - This command is sent to the scale to clear the contents of the accumulator (MC).
“U” - This command is sent to the scale to toggle among the configured units.