Salter Brecknell B220 - Manual (Page 21)

21 B220 Counting Scale User’s Manual
Protecting a PLU Go to PLU branch number (example shown is PLU 5),
sub-branch 4.
0 = Not protected
1 = Protected
Follow these procedures to calibrate your B220.
1. Press the On/Off key
then press the Clear
key. . .
Display shows CAL in top
line with weight displayed
on middle line.
2. Place calibration weight
on the scale and press
the Clear key. . .
If the weight is acceptable
and stable, the display will
show DONE in the middle
line for two seconds.
3. To exit the calibration
mode, press the On/Off
key then press the Zero
key.
1. Press the On/Off key
then press the Clear
key. . .
Display shows CAL in top
line with weight displayed
on middle line.
2. With no weight on the
scale, be sure display
reads 0. Press Zero
key if not at 0.
3. Press the Clear key. . . Clear is displayed.
Calibration
To Calibrate the
B220
To Revert to
Factory Calibration