Chief Manufacturing MFC Series User Manual
Page 8
MFC, PFC Series
Installation Instructions
8
Tilting Display
The display can be tilted up to 15
o
either backward or forward
from a straight upright position.
1.
Turn knob counterclockwise on back of head assembly to
loosen the tilt. (See Figure 9)
Figure 9
2.
Tilt display as desired, to a maximum of 15
o
either forward
or backward.
3.
Turn knob clockwise to tighten display on head assembly.
(See Figure 9)
CAUTION:
Tighten knob on back of head assembly to
prevent damage when moving the cart and display.
4.
If leaving the display in a straight upright position, it is
recommended that a bolt (not provided) be placed through
the head assembly (see Figure 9) to lock the display into the
upright position.
Cable Management
1.
Signal cables can be run down the front flap of the center
post and out the front of the post at any of the openings.
(See Figure 10)
2.
The display power cord can be run through the top and
down through the post to exit out the back. (See Figure 10)
3.
Any accessory power cords can be run through the front
and down through the post to exit out the back. (See
Figure 10)
4.
Install the snap-on covers to any opening that is not being
used. (See Figure 10)
5.
To remove the snap-on covers, grip the sides of the cover
in the middle and pull off. They can also be removed by
inserting a flat-blade screwdriver into the bottom slot and
rotating the screwdriver.
Figure 10
Cart Use and Maintenance
CAUTION:
This cart is intended for use only with the
products and maximum weights indicated (125 lbs [56.70 kg]
for the MFC, and 200 lbs [90.72 kg] for the PFC). Use with
other products or products heavier than the maximum
weights indicated may result in instability causing possible
injury.
WARNING:
CART CAN TIP OVER RESULTING IN RISK
OF INJURY. Do not allow children under 16 to move cart.
Only adults should move this cart. Move cart slowly. Apply
moving force on narrow dimension. Never apply force at top -
always push near middle. Push, don’t pull.
lock display
lock display
1
3
4
(MFC Shown)
Place optional bolt
(not provided) here
to lock in an upright
position.
2
(Rear
view of
center post)
(Front view
of center post)
Exit for
power
cables
1
3
Exits for
signal cables
Snap-on
covers