Catler CG 8010 - Manual (Page 18)

18
TROUBLESHOOTING
Problem Possible Cause What to Do
Grinder does not start after
pressing START/CANCEL
button. • Grinder not plugged in!
• Grinder is overheated.
• Bean hopper not attached correctly.
‘LOCK BEAN HOPPER’ will be displayed
on LCD screen.
• Plug power cord into power outlet.
• Remove power plug from power outlet. Leave for 20 minutes to
cool down before using again.
• Lock bean hopper into position.
Motor starts but no ground
coff ee coming from grind
outlet. • Incorrect button press.
• No coff ee beans in bean hopper!
• Grinder/bean hopper is blocked.
• Press START/CANCEL or PORTAFILTER SWITCH to activate.
• Fill bean hopper with fresh coff ee beans.
• Remove bean hopper. Inspect bean hopper & grind heads for
blockage. Replace parts and try again.
Motor starts but operates with
a loud ‘racket’ noise. • Grinder is blocked with foreign item or
chute is blocked.
• Moisture clogging grinder.
• Remove bean hopper, inspect burrs & remove any foreign body.
• Clean burr heads and chute (refer to Care & Cleaning instructions).
• Leave burrs to dry thoroughly before re-assembling. It is
possible to use a hair dryer to blow air into grinder inlet (lower
burr) to dry.
Unable to lock bean hopper
into position. • Coff ee beans obstructing bean hopper
locking device.
• Remove bean hopper. Clear coff ee beans from top of burrs. Re-
lock bean hopper into position and try again.
Not enough/too much coff ee
grind. • Grind amount requires adjustment. • Press AMOUNT button to change grind amount.
• Use ADJUST AMOUNT dial to fi ne tune the amount ‘More or Less’.
Portafi lter overfi lls. • It is normal for the correct amount of coff ee to appear overfi lled
in your portafi lter. Untamped coff ee is three times the volume of
tamped coff ee.
Emergency stop? • Press START/CANCEL button to stop operation.
• Unplug power cord from power outlet.
TROUBLESHOOTING
153124_CG_8010_EN_.indd Odd1:18 153124_CG_8010_EN_.indd Odd1:18 17.5.11 13:10 17.5.11 13:10