BoonDocker ARCTIC CAT: 2012-14 ProClimb M8 Intercooled - Manual (Page 7)

31. Lubricate the upper and lower injector o-rings with
assembly lubricant and install the auxillary injectors
into the fittings on the torque tubes.
32. Install the fuel rails on to the auxilliary injectors with
the fuel line “T” on the mag side of the machine.
33. Locate the stock fuel line feeding the stock fuel rail.
Measure approximately 1-1/2” back from the fuel rail
and cut the fuel line.
34. Install the barbed “T” fitting from the auxilliary injec-
tor fuel lines into the stock fuel line and secure using
the supplied hose clamps.
35. Plug the Control Box injector harness into auxillary
injectors. Unplug the stock injector connectors and
plug the matching CB injector harness connections
inline with these connectors. Unplug the Throttle Po-
sition Sensor on the MAG end of the throttle-bodies
and plug the matching CB injector harness connec-
tors inline.
36. Unbolt the stock ground wire next to the chaincase
and add the Control Box injector harness ground
connector.
BoonDocker tollfree: 877-522-7805 local: 208-542-4411 fax: 208-524-7381 www.boondockers.com 7