BoonDocker ARCTIC CAT: M1000 Race Gas - Manual (Page 22)

Revised 11/18/08 Arctic Cat M-1000 Turbo Installation instructions Page 22
www.boondockers.com............................
BoonDocker
..........................................877-522-7805
C. Using an air saw or band saw, trim the exhaust heat
shield as shown in picture
D. Reinstall the heat shield to the sled.
E. To save you a headache, install the 2 high tension
exhaust springs on the right side of the pipe first.
This allows you to use the exhaust pipe to torque
the springs instead of a spring puller. Be sure to
install the short hook onto the pipe side and the
long side of the spring to the Y pipe.
F. Be sure to add the 4-hole gasket on the turbo side of
the pipe. Fasten this connection using the provided
8mm bolts with lock nuts.
G. Install the remaining high tension exhaust springs
Step 14: Oil Catch Can
Parts Needed: Tools Needed:
Oil catch can Basic tool set
19” of ½ hose Drill with ¼” drill bit
¼ x1” bolt
¼” nylon lock nut
¼” flat washer
A. Set the oil catch can in place and mark, then
drill the mounting hole using a ¼” drill bit.