BoonDocker POLARIS: Non-turbo Control Box 2011-12 PRO RMK 800 - Manual (Page 3)

BoonDocker Performance – 2379 Heyrend Way, Idaho Falls, ID 83402 – 208-542-4411 / 877-522-7805
www.boondockers.com – email: [email protected] – fax: 208-524-7381
Revised 1-20-11 Copyright © 2011 Boondocker Page 3 of 17
IV. Battery / Jumper Connector
A battery connector and jumper is supplied with the Control Box:
1. Battery Connector
The Fuel Control Box is designed to operate without a battery. It will be
on whenever power is applied to the fuel injectors. However, by
disconnecting the Control Box’s TPS wire or Nitrous Harness and
plugging in the supplied Battery/Jumper Connector with a 9-volt
battery (not included) INTO THE CONTROL BOX, you can operate
the Fuel Control Box without the sled running.
2. Jumper Connector
The jumper is used for troubleshooting only. If your sled will not run or
will not idle correctly, disconnect the EFI harness from the Fuel Control
Box and plug the Battery/Jumper Connector INTO THE
BOONDOCKER EFI HARNESS to bypass the Fuel Control Box. The
injectors are now connected directly to the sled’s ECU through the
Boondocker EFI harness. Caution: This is only to be used to test at an
idle. Without the Fuel Control Box, no fuel can be added to the stock
fuel quantity. If your sled will not run with the Jumper, then unplug the Boondocker EFI harness above the throttle
bodies and plug the stock connectors together.
V. Control Box Operation
The control box is powered only when the injector power is on which occurs during start-up and when the engine is
running.
1. Startup Screen
When the box is first turned on (by the engine or battery), the Startup screen is displayed. Press any key to go to the
main menu. An example Startup screen display is shown below:
Polaris Pro RMK•
5B5jBD N2O:ADJ
In the example shown above, this screen displays the following information:
Polaris Pro RMK
Sled model. This box is designed for the Polaris RMK without a turbo.
Boxes for other sleds will have other lettering.
5B5jBD
This is the software version of the box. The box can be reprogrammed only
by sending the box back to Boondocker. Have this number handy when you
call Boondocker for technical support.