BoonDocker POLARIS: Non-turbo Control Box 600/700/800 IQ Dragon - Manual (Page 3)

BoonDocker – 2379 Heyrend Way Idaho Falls, Idaho 83402 – 208-542-4411 / 877-522-7805
www.boondockers.com – email: [email protected] – fax: 208-524-7381
Revised 1-15-08 Page 3 of 14
III. Control Box Mounting Locations
The Control Box can be mounted under the hood, on the dash, or on the handlebar riser using the supplied Velcro strips.
Before applying the adhesive strips, thoroughly clean each surface (rubbing alcohol works well). It is also best if each
surface is room temperature.
If the box is mounted under the hood, keep the box away from excess heat (like the exhaust), and away from the ignition
coils.
Note: The Control Box is designed to be splash proof. Do not submerge or subject the box to high-pressure spray.
IV. Battery / Jumper Connectors
Two jumpers are supplied with the Control Box:
1. Battery Connector
The Control Box is designed to operate without a battery – the box will
turn itself on whenever power is applied for the fuel injectors. However, a
9-volt battery (not included) can be plugged into the box through the
Control Box’s connectors with the supplied Battery Connector in order to
operate the box without the sled running.
2. Jumper Bypass Connector
The Jumper/Bypass connector can be used to bypass the Control Box in
case the sled needs to be run without the Control Box. Disconnect the
Control Box from the EFI Plug-in box plug in the Jumper connector. This
will connect the injectors directly to the sled’s ECU.
V. Control Box Operation
The control box is powered only when the injectors are on which occurs for a few seconds when the key is first turned on
and when the engine is running. Up to 5 different maps are stored in the box (currently all with zero values). The box will
remember what map was last selected and what its settings are – you do not need to do anything to save a map.
1. Startup Screen
Every time the box is first turned on (by the engine or battery), the Startup Screen is displayed. Press any key to go to the
Main Menu. An example Startup Screen is shown below:
Polaris 600-700
xxxxxxxx N2O:ADJ
.
In the example shown above, this screen displays the following information:
Polaris
Sled make
600-700
Sled model Note: Be sure the Control Box is for your make and model of sled!
xxxxxxxx
Code Version This is the version of code in the box. The version of code can only be changed
by sending the box back to Boondocker.
N2O:
Shows that this Control Box is nitrous capable.
ADJ Nitrous pressure regulator type (if used). This mode is described below in the Nitrous Section.