Climadiff CLE18- CLE51 User Manual

Page 21

Advertising
background image

21


4° INSTALLATION INSTRUCTIONS

Before using your wine cellar

•

Remove the inner and outer packaging.

•

Before connecting the cellar to the electrical socket, leave it in position for 24 hours. This will reduce the

possibility of malfunction of the refrigeration circuit due to transport.

•

Clean the inside using a soft cloth and lukewarm water.

Using your wine cellar:

Your wine cellar must be positioned in a room with an ambient temperature between + 16 and +38°C.

If the ambient temperature is higher or lower, the performance of your appliance may be affected and it may not
be possible to obtain temperatures between 5 and 22 degrees.

Installing your wine cellar

•

This wine cellar is designed for free-standing or built-in installation.

•

Position it in a place with sufficient strength to support its weight when loaded. To ensure that it is level,

adjust the height of the feet underneath.

•

To get the best from your appliance with the lowest energy consumption, do not place the appliance

close to a heat source (heater, cooker, etc.), do not expose it to direct sunlight, and do not place it in a

room which is too cold.

•

Connect the cellar to a single socket, leaving a 10 cm gap between the back of the cellar and the wall.

Be careful to support it, so that your wine cellar is perfectly level. (Use of a spirit level is recommended).
This will prevent any movement due to instability, causing noise and vibration, and will ensure that the
door seals perfectly.

Control panel

•

“RUN”

Power indicator

•

“LIGHT” Button

Lighting control button

•

“POWER” Button

On/Off switch

•

“DISPLAY”

Electronic temperature display

•

“UP” Button

+ Temperature setting button.

•

“DOWN” Button
- Temperature setting button.

•

“°C/°F” Button
- Reverse °C to °F.


.

Advertising