Stand-alone/master/slave fixture linking, Mounting, Tand – Chauvet Vue III User Manual

Page 9: Lone, Aster, Lave, Ixture, Inking, Ounting, Orientation rigging

Advertising
background image

Stand-Alone/Master/Slave Fixture Linking

1. Connect the (male) 3 pin connector side of the DMX cable to the output (female) 3 pin connector

of the first fixture.

2. Connect the end of the cable coming from the first fixture which will have a (female) 3 pin

connector to the input connector of the next fixture consisting of a (male) 3 pin connector. Then,

proceed to connect from the output as stated above to the input of the following fixture and so on.

Often, the setup for Master-Slave
and Standalone operation requires
that the first fixture in the chain be
initialized for this purpose via either
settings in the control panel or DIP-
switches. Secondarily, the fixtures
that follow may also require a slave
setting. Please consult the
“Operating Instructions” section in
this manual for complete instructions
for this type of setup and
configuration.

Mounting

O R I E N T A T I O N

This fixture may be mounted in any position provided there is adequate room for ventilation.

R I G G I N G

Hanging Clamp

It is important never to obstruct the fan or vents pathway. Mount the

fixture using, a suitable “C” or “O” type clamp. Adjust the angle of the

fixture by loosening both knobs and tilting the fixture. After finding the

desired position, retighten both knobs.

•

When selecting installation location, take into consideration lamp

replacement access and routine maintenance.

Note!
Clamp is sold separatel

•

Safety cables should always be used.

y.

•

Never mount in places where the fixture will be exposed to rain, high

humidity, extreme temperature changes or restricted ventilation.

Vue™ III User Manual

9

2007-05-10/15:08

Advertising