Code 3 235H Remote Strobe Power Supply - Manual (Page 5)

2. After the cables have been properly routed for each strobe head they will have to be terminated with the
three pin AMP socket housings provided. The cables are factory terminated with the proper AMP crimp
pins for insertion into the housings, see Figure 2. If there is a need to re-terminate any wires, Figure 2 also
includes stripping and crimping information.
RED WIRE - (ANODE) POSITION 1
WHITE WIRE - (TRIGGER) POSITION 3
STRIP INSULATION TO EXPOSE
BARE WIRE AS SHOWN
AMP 3 PIN SOCKET HOUSING
PN 1-480303-0
AMP SOCKET PIN
PN 60619-9
NOTE: USE AMP HAND TOOL PART NO. 90124-2 OR EQUIVALENT TO CRIMP SOCKET PINS TO THE
WIRES.
CRIMP TO INSULATION ONLY
CRIMP OVER BARE WIRE
1/8 INCH
BLACK WIRE - (CATHODE) POSITION 2
THIS END TO POWER
SUPPLY
FIGURE 2
WARN-
ING!
!
It is very important to observe the pin locations and color on the AMP three pin socket
housings. Improper connections could damage the remote strobe heads, see Figure 3.
FIGURE 3
Strobe Light Heads
Alternating
Outlets
Power-In/
Control
Power-In/Control
Harness
5