Code 3 275 Series Beacon - Manual (Page 6)

6
WARNING: RATED VOLTAGE IS INDICATED ON THE BACK OF REFLECTOR
DO NOT TOUCH GLASS PORTION
OF LAMP
12v APPLICATIONS ONLY
FIGURE 4
Maintenance
Do not oil or grease this unit. It is constructed with permanently lubricated bearings which do not need
lubrication. Keep the unit clean by disassembling it and clearing any debris or dirt. Clean lens and base
with mild soap and water, or CODE 3
® lens polish using a soft cloth. The lens may be removed, and the
lamps replaced as shown in Figure 4. Use only lamps with the same rated wattage and voltage.
Use no SOLVENTS on lens.
Failure to follow above warnings or installation and user instructions can result in loss of warranty coverage.
Lamps are extremely hot! Allow to cool completely before attempting to remove. Gloves
and eye protection should be worn when handling halogen lamps as they are pressurized and
accidental breakage can result in flying glass. !
WARNING!
BULB P/N
T01543