Code 3 Caprice Side Marker LED light - Manual (Page 2)

2
Installation Instructions
STEP 1, ACCESS FRONT FENDER
FROM WHEEL WELL BASE BY
REMOVING (2) BOTTOM PHILLIPS
HEAD SCREWS FROM WHEEL
WELL COVER
STEP 2. PULL OUT WHEEL WELL
COVER AT BASE TO GAIN ACCESS
FOR PUSHING OUT THE BOTTOM
CLIPS ON THE SIDE MARKER
COVER IN THE FRONT FENDER.
STEP 3. REMOVE THE SIDE
MARKER COVER FROM FENDER
STEP 4. INSTALL OR LOCATE
(4 wire) WIRING HARNESS FOR
LIGHTS
STEP 5. INSTALL (4) PIN WATERPROOF
CONNECTOR SUPPLIED IN KIT ONTO
WIRE HARNESS IN VEHICLE
STEP 6. PLUG IN LIGHT HEAD TO HAR-
NESS AND SNAP LIGHT HEAD ASSEM-
BLY INTO VEHICLE FRONT FENDER.
WIRE IDENTIFICATION TABLE:
Green wire- Syncronization
White wire- Change flash pattern
Red wire- Power
Black wire- Ground