Direct wiring, Pole or stanchion mounting – Code 3 DashLaser User Manual
Page 6
CUSTOMER SUPPLIED
SWITCH AND 10AMP FUSE
+12V
RIBBED WIRE IS
POSITIVE
SOLID CHASSIS
GROUND (EARTH)
Permanently mounted units can be tipped to
remove lens. Clearances are shown here.
PLUMBING
HARDWARE
MAGNET
ACTS AS
SPACER
ELECTRICAL
CONDUIT
HARDWARE
The mounting kit can be used to mount the DashLaser
®
to a 1/2" or 3/4" pipe by using standard electrical (1/2") or
plumbing hardware (see illustrations).
Pole or Stanchion Mounting
Tether Cord
FIGURE 11
Direct Wiring
If you wire the DashLaser directly to a power
source instead of using the cigarette plug, be
sure the wire from the DashLaser is positive,
and connects to the +12 volt power supply.
The smooth wire is the ground (earth) wire. It
is advisable to put a 10 amp in-line fuse on the
ribbed wire between the DashLaser and the
power source.
FIGURE 10
FIGURE 9
6