Code 3 MX 7000 - Manual (Page 4)

Hook-on Mounting
Begin the installation by attaching the rubber feet to the mounting brackets using the black 1/4" carriage bolts and 1/4" nuts
provided. See Figure 3 (Do not install shims at this time).
Place the light bar upside down on a table or other work surface, being careful not to scratch the lenses. Slide the 5/16"
carriage bolts into the frame. Secure the mounting brackets finger tight so they support the weight of the light bar, but still are
positionable. Locate the vehicle on a level surface.
Place the light bar on the roof of the vehicle. Place a soft pad in the center of the roof to protect the paint. The mounting
brackets must be placed so that the rubber feet are resting on the curved section of the roof, see Figure 4. This is the
strongest part of the roof. Once the light bar is centered, tighten the mounting bracket to the light bar.
Using a tape measure and a level, center the light bar from side to
side and locate a position on the roof where the light bar is
level.
Figure 4
Figure 3
(Dual Speaker Installation in 52" & 58 1/4" Light bars) Using the same procedure as above, install the speakers using the
mounting holes in Figure 2 (For a Code 3 "LP" speaker). When using the two speakers , follow the manufacturer's
instructions for correct phasing of speakers.
4