Code 3 Sprinter User Manual
Page 5
Advertising
![background image](/manuals/635351/5/background.png)
3. To install the positive and negative power wires, strip 1/4” of insulation from the end of the wires, and install the blade
connectors onto the ends of the appropriate wires. The “+12V” positions may be connected either directly to a +12V
source (such as a battery), or through a switch (such as an ignition switch). (See proper fusing requirements on page
6 prior to making any wire connections to battery or ignition switch)
Figure 1 - Wiring Diagram
5
Advertising