Coral Industries 6000 Pivot Door - 7631 - Manual (Page 7)

7631 / 7131-GP 9/06
Smooth
sharp
point.
D
Drip Rail
Drip Rail Sweep E
INSIDE OF SHOWER
Measure width of door
panel at bottom on
inside of shower.
6-32 x 1 1/4" Pan
Head Screw
J
OUTSIDE OF SHOWER
Exterior
Handle
J
Interior
Handle
The handle for your door may have been pre-
installed. If so, disregard this step and continue
installation.
Mount interior and exterior pull handles from
pull handle kit (J) onto door panel using
6-32 x 1 1/4" pan head screws.
10 Pull Handle Kit
(J)
From inside shower, measure width of door
panel at bottom. Drip rail (D) should be 1/2"
shorter than door width. If longer, cut to proper
length. Smooth cut end of drip rail fin to remove
sharp point.
For one-piece vinyl drip rail (V667), continue with
Step 11b.
Slide vinyl sweep (E) into slot on back of drip
rail. Trim end even with edge of drip rail.
11a Drip Rail
(D)
Clean bottom channel of door before
mounting drip rail. After mounting, do not
remove or reposition. Allow 72 hours
curing time for maximum bond.
Position drip rail on inside surface of door panel
as described below:
• Side-to-side placement: Edge of drip rail
should be flush with edge of door panel on hinge
side of door.
• Vertical placement: Vinyl sweep should extend
1/2" below bottom of door panel on opening
side. Angle drip rail so that vinyl sweep extends
3/4" below bottom of door panel on hinge side.
This will create an 1/4" slope from opening to
hinge side for water drainage.
Mark position. Remove drip rail from door. Peel
protective cover from tape, and press into place.
Insert drip rail plug (H) into groove of drip rail on
opening side of door.
11b Drip Rail
(D)
H
D
Drip
Rail
INSIDE OF SHOWER Drip Rail Plug
1/2"
1/4" drop from
Opening Side
to Hinge Side
for drainage
Door
Panel
Opening Side
Hinge Side
Drip Rail flush
with edge of
Door Panel
E Vinyl Sweep
3/4"
Hinge Side
Drip rail may be additionally secured using 8A x 3/8" truss head
screws. When drilling in door panel, make certain drill does not hit
glass. Glass is seated approximately 1/2" into channel.