Coral Industries 7000 Swing Door/DPNL - 650 - Manual (Page 4)

650 6/09
On opposite side of unit, place hinge door stop (with door
panel attached) over wall jamb with bottom of door stop
seated in sill. For safety purposes, door should be installed
to open out from shower.
Measure from wall to wall (over the top of both jambs) and
cut header (C) to that measurement.
Lower header into place over jambs.
Door Panel
A
Sill
OUTSIDE OF SHOWER
B Jamb
B
Jamb
C
Header
Door Panel
B
Jamb
OUTSIDE OF SHOWER
6 Hinge Door Stop and Door Panel
If magnetic strips do not seal tightly, reverse polarity
by removing strip from door stop and replacing it with
the previous top end to the bottom end.
At bottom of door, snap sill / header insert (D) into sill with
tall edge of insert toward outside of shower.
At top of door, snap sill / header insert (D) into header with
tall edge of insert toward inside of shower.
C Header
OUTSIDE OF SHOWER
D Top Sill/Header Insert -
tall edge toward inside
of shower
A
Sill
D
Bottom Sill/Header Insert -
tall edge toward outside of shower
E Magnetic Door Stop
E
Magnetic Door Stop
7 Header
(C)
8 Sill / Header Inserts
(D)
Magnetic
Door Stop E
Door Panel
Hinge Door Stop
Door Panel
Door
Panel
Hinge Door Stop
attached to Door
Panel