Coral Industries 7000 Swing Door/ILP - 600 - Manual (Page 4)

600 7/09
On opposite side of unit, place hinge door stop (which is
attached to door panel) over wall jamb with bottom of door
stop seated in sill. For safety purposes, door should be
installed to open out from shower.
Measure from wall to wall (over the top of both jambs) and
cut header (C) to that measurement.
Lower header into place over jambs.
Door Panel
A
Sill
Hinge Door
Stop
attached to
Door Panel
OUTSIDE OF SHOWER
B Jamb
B
Jamb
C Header
B
Jamb
B
Jamb
OUTSIDE OF SHOWER
6 Hinge Door Stop and Door Panel
If magnetic strips do not seal tightly, reverse polarity
by removing strip from door stop and replacing it with
the previous top end to the bottom end.
At bottom of door, snap sill / header insert (D) into sill with
tall edge of insert toward outside of shower.
At top of door, snap sill / header insert (D) into header with
tall edge of insert toward inside of shower.
B
C Header
B Jamb B
OUTSIDE OF SHOWER
Jamb Jamb
D Top Sill/Header Insert -
tall edge toward inside
of shower
B
A
Sill
B
Jamb
B
Jamb
Jamb
D
Bottom Sill/Header Insert -
tall edge toward outside of shower
Magnetic Door Stop
E
Magnetic Door Stop
7 Header
(C)
8 Sill / Header Inserts
(D)
Magnetic
Door Stop E
Jamb
B
Door Panel
Hinge Door Stop
E
Jamb
B
Jamb
B
Setting Blocks
X
Panel Glass