Coral Industries Steam Swing Door/ILP - 0S3 - Manual (Page 5)

0S3-GP 6/02
Mount interior and exterior pull handles,
from pull handle kit (L), onto door panel
using 6-32 x 1 1/4" pan head screws
provided.
9
6-32 x 1 1/4"
Pan Head
Screw
Interior Handle
Exterior
Handle
OUTSIDE OF SHOWER
L Pull
Handle
Kit
Handle for your door may be
pre-installed. If so,
disregard this step and
continue installation.
10
Secure sill dy drilling, from outside
shower, through sill into double channel
and door stop.
Jamb
B
Side Panel
8A x 3/8 "
Truss Head
Screws
K
Double
Channel
D
Sill
A
OUTSIDE OF SHOWER
From inside shower, measure width of door panel at
bottom. Drip rail (F) should be 1/2" shorter than
door width. If longer, cut to proper length.
Slide vinyl sweep (N) into slot on back of drip rail.
Trim ends even with edges of drip rail.
Smooth cut end of drip rail fin with a file to remove
sharp point.
Drip Rail
Sweep
INSIDE
OF SHOWER
Measure
N
F Drip Rail
Contour
11