Coral Industries Style Swing Door/ILP (1/4 Frameless) - 670 - Manual (Page 3)

670 7/09
Position jamb (B) on sill with short legs against wall and bottom
of jamb inside sill. If necessary, file sharp edges on bottom of
jamb to fit rounded corners of your unit.
Align jamb vertically using a level. Drill mounting holes through
jamb into wall using 1/8" drill bit. Mounting holes are normally
located 3" from top and bottom of jamb and at center.
Secure jamb to wall using 8A x 1 1/4" pan head screws (L).
Repeat for opposite side.
Level
Sill A
OUTSIDE OF
SHOWER
Drill 3" from top and bottom
of jamb, and at center.
Jamb B
File sharp
edges to fit
rounded
corners of
your unit if
needed.
When anchors (H) are used, holes should be drilled
using 3/16" drill bit. (Use masonry bit for tile.)
8A x 1 1/4"
Pan Head Screw L
4a Magnetic Pull Handle Kit
(M)
Style Series
Mark center of glass on opening edge of door panel.
Wrap handle vinyl, from magnetic pull handle kit (M), over
edge of glass. Thinner glass may require the use of two pieces
of vinyl to insure a tight grip between handle and glass.
Hold metal slide for installation later. With a rubber mallet, tap
handle, with magnet attached, onto glass. Magnet should face
inside of shower.
M
Center
Magnet Holder
with Magnet
(Magnet faces
inside of shower)
Handle
Vinyl
K
OUTSIDE
SURFACE OF
DOOR
Magnetic Pull
Handle
(Magnet faces
inside of shower)
4 Handle
Decide the placement of side panel and the opening side of your
door. Door is normally installed to open on the side of unit nearest
to showerhead.
Lay door panel, with hinge door stop attached, on a work table
covered with cardboard or carpet. Position so that hinge door
stopswings up as shown. This will be the outside surface of your
door panel (facing up).Adjust door on work table so that the
opening edge and handle holes extend past table edge.
Step 4a: Style Series . Step 4b: Freestyle Series .
Hinge Door Stop
(Swings toward outside
surface of glass)
Outside surface of panel
OVERHEAD VIEW Showerhead
Door
Normal
opening side
Panel
4b Magnetic Catch Kit
(K)
Freestyle Series
Mark center of glass on opening edge of door panel.
Wrap handle vinyl, from magnetic catch kit (K), over edge of
glass. Thinner glass may require the use of two pieces of vinyl
to insure a tight grip between handle and glass.
Hold metal slide for installation later. With a rubber mallet, tap
magnet holder, with magnet attached, onto glass. Magnet
should face inside of shower.
3 Jambs
(B)
Center
Handle
Vinyl
OUTSIDE
SURFACE OF
DOOR